loading
reading
writing
saving
searching
30mm Hex Mill machine Table elevation Crank handle spare milling parts - $40 (Grand Rapids NW side)
QR Code Link to This Post
30mm Hex Mill machine Table elevation Crank handle spare milling parts hand tool
I had a couple of these, I added a photo of the hand held part of the handle from another one I had so you can see what the handle should look like if it was complete as seen in the last photo.
But this one is missing that black plastic part as you can see in the one photo.
This offset handle is in good used condition
I am not sure what model machine it fits might even be
for a surface grinders or a tool & cutter grinder
etc, but I would guess a Cincinnati or maybe a
Milwaukee K&T Kearney & Trecker or some other large mill.
The hex shape hole measures 1.181" on the back side which is 30mm metric
but where you slide it on to the shaft it
actually measures about 30.6mm
I am sure this
is to make it easier to slide it over the hexagon shaped shaft
easier and faster.
Overall Length is 11-1/2"
The offset is about 5"
Looks to be made of cast iron, the part
of the handle where you hold on to measures 10mm x 82.2mm long and it is bent a little bit, you should be able to straighten that. The shoulder next to that measures 17.9mm diameter.
I do not see a name on it, looks pretty old.
The outside diameter of the round section measures 46mm x 38mm long
Overall length of the hex inside is 60mm
Vintage machinery rare hard to find
spare parts
Call Doug
616-460-213zero
Please take a minute and look through some of my other items, just type my phone number in to the search window exactly as it is written just above this sentence.
Thanks!!